Fellow Stagg EKG CLI

Control a Fellow Stagg EKG kettle over its local HTTP command interface from the terminal.

The CLI talks to the kettle at /cli?cmd=..., prints structured key/value responses when available, and keeps the low-level command surface available for recovery when you need it.

Created by @erikrogne (Erik Rogne).

Quick Start

# Use either --host or --base-url.
fellow-stagg-ekg-pp-cli --host 192.168.1.86 status

# Fetch the current state or settings.
fellow-stagg-ekg-pp-cli --host 192.168.1.86 state
fellow-stagg-ekg-pp-cli --host 192.168.1.86 settings

# Start heating after setting a target temperature.
fellow-stagg-ekg-pp-cli --host 192.168.1.86 heat --temp 95.5

# Send a raw command for recovery or exploration.
fellow-stagg-ekg-pp-cli --host 192.168.1.86 raw "buz sos"

Commands

• status - Show state, settings, and firmware info.
• state - Fetch the kettle state.
• settings - Fetch the kettle settings.
• clock - Fetch the kettle clock.
• info - Fetch firmware info.
• heat - Start heating, optionally after setting a target temperature.
• off - Turn the kettle off.
• set-temp - Set the target temperature.
• set-setting - Call setsetting, setsettingd, or setsettings directly.
• units - Switch the display units.
• button - Press or release button 1 or 2.
• dial - Rotate the kettle dial.
• beep - Run buzzer commands.
• raw - Send an arbitrary command string.

Environment

• FELLOW_STAGG_HOST
• FELLOW_STAGG_URL
• FELLOW_STAGG_PORT
• FELLOW_STAGG_TIMEOUT